Stainless Steel Pet Bowls Transferring Instructions
Read these instructions completely before you begin.
Supplies Needed
• Dog or cat bowl
• Shrink Wrap.
• Heat Tape
• Heat Gloves
Step 1: Preheat Your Oven
Shrink Wraps are designed for use in regular or convection ovens or industrial conveyor ovens, only. not use in a microwave oven under any circumstances. Preheat oven to Bake at 400o F in convection oven. For best results, oven must be at full temperature prior to using UltraWraps.
Oven Temperature: Bake at 400o F
Dwell Time: 2.5 minutes for 64 oz. Bowl
2.5 minutes for 32 oz. Bowl
Note: These instructions, including transfer times and temperatures, are based on the inks, paper, ovens and products we use. Your inks, papers, etc. may require adjustments in your time/temp settings.
Step 2: Print Your Transfer
Print your transfer(s) in the normal way. If you are printing both sides of the bowl it is best to cut the transfer in half. (Fig 1)
Step 3: Tape transfer to small or large bowl. Leave a small image gap for best results. (Fig 2)
Using the Shrink Wrap
4: place the film circle around the pet bowl. Tape the film in position on one or two places to keep it in position around the wall of the pet bowl. Note: there are two sizes of Shrink wrap for the the two size pet bowls we offer. Place in preheated oven for 10 seconds and check to insure the film shrinks in correct position. Then close the oven door and back for the prescribed amount of time.
Step 5: Place the wrapped bowl in a preheated oven. Do not place closer than four inches from the heating coils.
Step 6: Remove from oven and immediately remove Shrink Wrap from the bowl. Items are HOT! We recommend using oven heat gloves.
Troubleshooting & Tips:
1. Place hot pet bowls in front of a fan to keep the sublimation dye from ghosting on the pet bowl.
Customer Support
For support on these or any of our products, please call our toll-free number for assistance: 877.795.1500. You may also write to us at Support@LaserReproductions.com.
