Rock Glass/Candle Holder Transferring Instructions
Read these instructions completely before you begin.
Supplies Needed
• Coated Rock Glass
• Rock Glass Ultra-Wrap. Sku WRAPRG
• Heat Tape
• Convection Oven
• Design Template
• Heat Gloves
Important: Read instructions before use.
Ultra-Wraps have been tested and proven to work successfully for hundreds of consecutive uses per wrap. However, deliberately stretching the wrap beyond its specifications can result in loss of tension or tearing. Likewise, over-heating the wrap or placing it too close to the oven heating coils can weaken the wrap, causing it to burn or tear. To ensure the full life of each Ultra-Wrap:
• Never over-stretch the wrap beyond the simple distance needed to connect the hook to the
support bar.
• Never use a wrap for a product other than the one it is intended.
• Do not bake the Ultra-Wrap at a temperature hotter, or a time longer, than recommended. See
Step 1 for time and temperature recommendations.
• Never place the Ultra-Wrap closer than 4” from the oven heating coils.
Failure to follow these instructions could cause product failure and void any product
warranty.
Step 1: Adjust Your Oven
Ultra-Wraps are designed for use in regular or convection ovens or industrial conveyor ovens, only.
Do not use in a microwave oven under any circumstances. Preheat oven to Bake at 400o F in convection oven. For best results, oven must be at full temperature prior to using UltraWraps.
Oven Temperature: 400o F in convection oven.
Dwell Time: 5 – 6 minutes
Note: These instructions, including transfer times and temperatures, are based on the inks, paper, ovens and products we use. Your inks, papers, etc. may require adjustments in your time/temp settings
Step 2: Print your transfer(s) using this method:
A. Open template from our website.
B. Open image file.
C. Select the area of your image that you want to have on your rock glass. Paste into your template. Print out your image transfer.
Step 3: Tape transfer to the rock glass. We suggest leaving a 1/2-inch gap on the transfer.
Step 4: Put the Ultra-Wrap on the rock glass.
Step 5: Hold one end of the wrap against the rock glass. With your other hand, pull the wrap up and around the right side of the rock glass. Connect the wrap so it locks together.
Step 6: Place the wrapped jar in a preheated oven. Do not place closer than four inches from the heating coils.
Step 7: Bake rock glass for 5 – 6 minutes.
Step 8: When done, remove wrapped glass from oven. Remove wrap and transfer from rock glass. Items are hot! Apply a light fan to cool.
ALTERTNATIVE PRESSING METHODS:
1. You may try pressing the rock glass in a mug press. 400 degrees for approximately 4 minutes. If it doesn’t fit you can add a layer or two of our green thermal rubber strips.
Call for more information about this.
2. You may use shrink film to decorate the glass. (In lieu of using an Ultra-wrap.
We offer this shrink film at a very low cost. Please call us to add to your order.
Customer Support
For support on these or any of our products, please call our toll-free number for assistance:
877.795.1500. You may also write to us at Support@LaserReproductions.com.
