Stainless Steel Matte Black License Plate Frames

LICPFB
predefined_license_plate_frame_black_626x497.png
predefined_bolts_for_license_plate_frame_626x778.png

These US standard-size license plate frames are great for personalizing any vehicle.
Frames and inserts won't rust or corrode or fade.

GREAT AUTO ACCESSORY: Accessorize almost any car, truck, or trailer with this personalized license plate frame.
Great gift idea for family and friends!

License frames fit all standard-size license plates (12" x 6") with two holes for mounting.
AND don't forget to order our stainless steel bolts with matching decorative covers! Two bolts and two cover caps per set.

Materials:

  • Frame: Heavy-duty 4.25 oz. Stainless Steel Metal, Matte Black
  • Two Frame inserts: Sublimatable. 0.040"-thick white aluminum inserts are included for top and bottom detents.

NOTE: You will need to buy a two-part epoxy that you will find at any hardware store to affix this aluminum to the Plate.

Insert sizes:
The top insert is 6.12 long x .56 wide
Bottom insert is 10.5 long x .75 wide

Price Calculator

 $ 7.20
 $ 2.40
SUBTOTAL : $ 7.20
Unit Price :$ 7.20

Read these instructions completely before you begin.

Supplies Needed

  • Sublimatable Aluminum Inserts
  • Sublimation Transfer
  • Heat Tape
  • Heat Gloves
  • 2-part epoxy to affix inserts onto the license plate frame.

Step 1: Adjust Heat Press

  • Heat Press Temperature: 400°F
  • Dwell Time: 50 seconds
  • Pressure: Firm

Note: These instructions, including transfer times and temperatures, are based on the inks, paper, presses, and products we use. Your inks, papers, etc. may require adjustments in your settings.

Step 2: Design & Print Your Transfer

Design your transfer based on the insert size and shape. If you are designing a full-bleed image, we recommend that you design the transfer so that it is at least 1/8” larger than the piece all the way around. This bleed allowance is already built into our templates. Our templates are posted on our website at http://www.laserreproductions.com/Design-Templates.html.

Step 3: Transfer the Image

1. The Heat press should have Teflon on the bottom.

2. Tape the transfer in position in two places with the two inserts so it doesn’t move when pressing.

3. Place your transfer face-up on the Teflon heat table.

4. Thus the aluminum insert is coated side down on the transfer. Be sure to remove the protective film from the insert before pressing!

5. Tape in position in two places to ensure registration.

6. Using Firm pressure, press for 50 seconds @ 400°F.

Step 4: Cooling

Carefully remove inserts from the press using heat gloves. Remove the transfer paper and allow the inserts to cool.

Adhering the Inserts onto the License Plate Frame

To secure inserts onto the license plate frames, apply equal amounts of two-part A & B epoxy (either Loctite Epoxy or JB Weld 4 oz. bottles) to the center area of the license plate. Mix well with a small, thin stick. Place the insert in the register onto the license plate frame and let it sit undisturbed for an hour. You can place a little weight on top of the insert to keep it in close contact with the frame while drying. If you have any problems or questions, stop production immediately and contact Technical Support for help.

Technical Support

For support on these or any of our products, please call our toll-free number for assistance: 877.795.1500. You may also write to us at support@laserreproductions.com.